Rebuilt PINES #2 LH Hydraulic Tube Bender to Include (Core Provided by UTB):

Bender is upgraded with a COMPTROL digital controller. The controller is by Sierra Controllers. The controller has a quick disconnect to the main electrical box. Specifications are listed below.

Intuitive menu driven part & setup screens

Each bend parameter can be programmed specifically for each bend
Alpa-numeric part names
Massive Part Storage & bends per part
Integrated manual & automatic controls
Programmable mandrel oscillation
Early Mandrel Extraction
(3) Return Modes (manual, semi-automatic, & automatic)
Pressure Die Assist (Boost) delay (If bender is equipped hydraulically)
Bend Arm deceleration (If bender is equipped hydraulically)
Automatic parts counter
Status line for the run mode
Display of Bend arm angle & current part bend data
Easy enabling & disabling of bender devices
Easy toggling of bender inputs
Two mandrel extractor sequences (Normal & Inhibited)
Automatic Mandrel lube intervals (If bender is equipped)
(4) Line x (20) character Vacuum Fluorescent Display
Controller board covered by (2) year warranty

Swing Arm:
Removed & inspected
Repair spindle keyway (If necessary)
Skim cut bend die mounting surface / Repair Bend Die Keyway (If necessary)
Remove & replace New Timken cup & cone bearings
New spanner nuts
New spindle key
New fasteners
New Bend Die Key
New Inner Locating Ring
New Sprocket

Stationary Arm:
Inspected
Replace fasteners

The swing arm & stationary arm slides are replaced with new Steel Slides w/Bronze wear strips attached including back up bolts and nuts. The wear strips, clamp bars, gibs, rod ends, bushings in toggle links, pins, snap rings & grease zirks replaced with new.

Hydraulic cylinders:
New Bend Cylinder 5” Bore x 19” Stroke
New Clamp & Pressure Die Cylinders
New Mandrel Extractor Cylinder

Hydraulics All New:

New Manifold
New Vickers PA5 Directional Bend Valve & Flow Control
New Vickers PA5 Directional Clamp Valve & Flow Control
New Vickers PA5 Directional Pressure Valve & Flow Control
New Vickers PA5 Directional Mandrel Valve
New Vickers PA5 Directional PDA Valve, Pressure Reducing & Flow Control
New Vickers Piston Pump
The suction strainer, oil sight glass & pressure gauges are replaced
New hydraulic hoses & fitting

New gaskets on side oil tank covers

New Lube USA electronic slide lubricator. Includes new junctions, meters, line, ferrules, & fittings

New main electric motor (TEFC) Totally Enclosed Fan Cooled C-Faced Adapted w/New Coupling

Electrical:

New Main Electrical box (NEED VOLTAGE)
New fused disconnect switch
New motor starter
New transformer
New wiring
New switches
New fittings
New Fuses
Spare Controller Keypad – Included

New Rear Sprocket pin & bushing

New #160 Front & Rear bend chain & connecting links

New PDA (Pressure Die Assist) Assembly – Linear Rail & Bearing w/ New Master Bar Assembly

New Clamp Die holder assembly. Adjustable t-slot face style

New Wiper Die Holder Assembly